![]() Try to aim for a maximum peak of around \xe2\x80\x936.0 dB (or 0.5 if you have your meters set to linear rather than dB). If the Recording Meters are not visible, click View > Toolbars and check Meter Toolbar. Do not let the meter bars actually reach the right edge, or the red hold lights to right of the meter will come on, indicating you will have distortion in the recording. While playing a loud part of your tape or record, adjust the Recording Slider on the Mixer Toolbar so the Recording Meters are almost reaching the right-hand end of the scale. I can record sound, but it sounds tinny and Audicy picks up background noise, since its not capturing audio right from the soundcard stream. PROBLEM: The only input source in my drop-down box is 'Internal Microphone'. Set the volume level of your recording inputĬlick in the Recording Meter, or click on the microphone icon and click "Start Monitoring". Mac computers have no built-in ability to record streaming audio playing on a sound device. SYSTEM: Running Audacity 1.3.7 on a Mac Air (running OSX 10.5.6 on an Intel Core 2 Duo chipset). If hardware playthrough is required, usually only needed for overdubbing, it is best to use an external USB or FireWire audio device that has a headphones jack for no-latency monitoring (such as the Behringer UCA 202 USB or Zoom H2 USB). Linux distributions specifically for music or media applications are likely to have JACK pre-installed, in which case low latency software playthrough can be configured in QjackCtl. ALSA has the optional alsaloop playthrough module in alsa-utils and PulseAudio has an optional module-loopback, but these modules may have noticeable latency and audio breakup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |